Frankfurt am Main / Germany
Wessels + Müller
Dortmund / Germany
Munich / Germany
Hanover / Germany
4.65501 Switching device, gear shift lever
The switching device 4.65501 generates the hydraulic signals required for changing gears, depending on the gear preselected by the driver.
Tips & Tricks
It is important to shift the gearbox to neutral before dismantling the switching device. Afterwards, first disconnect the supply pipe and then disconnect the electrical plug connections. In the last step of ismantling, the hydraulic lines are removed. The installation is carried out in reverse order. In doing so, the mounting torques must be observed. Now the hydropneumatic circuit can be vented. Make sure that there is no deformation or dirt on the cone of the vent valve.
The bleeding device should always be filled and stand still so that no mixture of hydraulic fluid and air is produced. It is ideal if the fully filled bleeding device stands still for approximately six hours before venting.
Construction of the switching device
Further articles from the product range of the brand DT Spare Parts
|Switching device||Switching device||Switching device||Control unit, gearbox switching|
|replaces||Kongsberg: 626662AM||Kongsberg: 630388AM||Kongsberg: 626661AM||Kongsberg: 627496AM|