Frankfurt am Main / Germany
Wessels + Müller
Dortmund / Germany
Munich / Germany
Hanover / Germany
1.19136 Servo pump
The 1.19136 power steering pump generates the hydraulic oil required for easy steering of the vehicle and supplies it to the steering gear.
Tips & Tricks
The equipment must be checked before the article is replaced. If a high water content or dirt particles are detected, the equipment must be replaced. In case of heavy soiling, the hydraulic system should be rinsed as described in the assembly instructions supplied with the article. The mounting surface must be cleaned. If sealant is used during assembly, it is important that no sealant enters the operating fluid circuit.
The erection screws must be mounted with the torque specified by the manufacturer. The connections should be installed by hand to prevent damage to the thread. Now ventilate the system: The steering wheel must be turned three times to the left and three times to the right when the front axle is raised. During the subsequent test run, the leakage check must be carried out and the level of the equipment must be corrected.
Structure of the servo pump
Further articles from the product range of the brand DT Spare Parts
|Servo pump||Servo pump||Repair kit, servo pump||Steering gear|
|replaces||LuK: 542 0048 10||50 10 239 659||1118098, 276140||940 460 3300|